Corporate Governance, Board Management & M&A ExitsPlaybook3 min readUpdated September 2026

Working Capital Pegs: A Worked Example for Founders

A working capital peg is the part of a purchase agreement that quietly decides whether you get more money after closing or have to send some back. It sets a target level of working capital, current assets minus current liabilities, that the buyer expects the business to have at closing, and compares that target against what actually shows up once the post-closing books are done.

The mechanism is simple in concept and easy to get wrong in the details. A worked example makes the mechanics clearer than the legal language usually does.

Setting the target in the first place

Say your business has averaged a certain level of net working capital over the last twelve months. The buyer will usually propose a peg based on that historical average, sometimes adjusted for seasonality if your revenue is lumpy. Push back if the buyer picks an unusually high or low month as the baseline instead of a trailing average, since a cherry-picked reference point built into the target can quietly work against you either direction.

How the true-up actually plays out

Picture a deal where the peg is set and, at closing, a closing statement is prepared showing actual working capital that came in below the target. Under a typical true-up mechanism, the seller owes the buyer the shortfall, dollar for dollar, usually paid out of an escrow or offset against a deferred payment. If actual working capital comes in above the target instead, the buyer usually owes the seller the excess. The mechanism cuts both ways, which is exactly why the target itself matters so much.

The accounting policy fight nobody warns you about

Two people can look at the same numbers and land on different working capital figures depending on the accounting policies applied, especially around revenue recognition for deferred subscriptions, bad debt reserves, and how prepaid expenses are treated. Nail down, in the agreement itself, that the closing statement uses the same accounting methods and policies as the historical numbers the peg was based on. Without that consistency requirement, either side can argue for policies that move the number in their favor after the fact.

Dispute resolution when the two sides do not agree

Most agreements route a working capital dispute to a neutral accounting firm rather than to litigation, since it is meant to be a numbers disagreement, not a legal one. Push for a firm both sides pre-approve, a defined process for submitting positions, and a binding result, so a disagreement over a few line items does not turn into a months-long standoff that delays the rest of your payout.

What to check before you sign the peg into the agreement

Confirm the target reflects a fair trailing period, that the accounting policies are locked to match your historical numbers, that there is a real dispute process with a deadline, and that any true-up payment has a clear timeline. If your books have any known messiness, such as deferred revenue that is hard to classify, flag it before signing rather than discovering the disagreement during the post-closing true-up, when the buyer already controls the business and you have a much weaker hand to negotiate from.

Confirm each of these points before the peg goes into the agreement:

  • The target reflects a fair trailing period, not an unusually high or low month that skews the baseline.
  • The accounting policies are locked in the agreement to match your historical numbers, especially on deferred revenue, bad debt reserves and prepaid expenses.
  • A real dispute process exists, with a deadline and a pre-approved neutral accounting firm, so a numbers disagreement does not become litigation.
  • Any true-up payment has a clear timeline for when the money moves and where it comes from.
  • Known messiness in your books, such as hard-to-classify deferred revenue, is flagged before signing.

A second worked scenario: when the number comes in above target

Say the same deal closes and, this time, the actual working capital figure lands above the negotiated target rather than below it. Under a standard true-up, the buyer now owes the seller the excess, on the same dollar-for-dollar basis that would have applied in reverse. Sellers sometimes forget this direction exists and focus only on the downside scenario during negotiation, which is a mistake: a target set unrealistically high protects the buyer in this direction and effectively caps how much upside you can ever collect, even in a strong quarter leading into closing.

Building your own estimate before the buyer sends theirs

Run your own trailing calculation using your actual accounting records before the buyer proposes a number, so you walk into the conversation with a specific figure and a clear rationale rather than reacting to whatever they suggest first. A seller who shows up with their own well-supported calculation, built from the same historical period the buyer will eventually want to use, tends to end up with a fairer target than one who simply responds to the buyer's opening number.

Executive Capability Standard

What Good Looks Like

A fair working capital mechanism uses a trailing average target, locked-in accounting policies that match your historical numbers, and a defined, binding dispute process with a real deadline.

Building The Capability (5-Stage Skill Ladder)

1. Learn:Pull your own trailing working capital numbers before the buyer proposes a target, so you know whether their number is reasonable.
2. Do Manually:Draft a one-page summary of your accounting policies for revenue recognition, bad debt and prepaid expenses to hand to the buyer's accountants before the peg is negotiated.
3. Delegate:Have your accountant or a fractional CFO negotiate the peg mechanics and review the closing statement before you sign off on any true-up.
4. Automate:Use a shared workflow or checklist tool to track the closing statement preparation and dispute deadlines so nothing slips past a contractual window.
5. Buy:Bring in an M&A attorney to draft the dispute resolution language and an accountant experienced in working capital disputes if a disagreement actually arises.

How to Get Started

Frequently Asked Questions

What happens if I disagree with the buyer's calculation of working capital?

Most purchase agreements route a genuine dispute to an independent accounting firm for a binding resolution rather than to court, since it is meant to be a numbers question. Check that your agreement names a specific dispute process and a deadline, rather than leaving it open-ended.

Can the working capital peg wipe out my whole payout?

Not if the peg is negotiated well. A fair trailing average and consistent accounting policies should produce a true-up that is a fraction of the total price. It can eat into your payout meaningfully if the target was set unfairly or your accounting policies shifted between the historical period and closing, so lock both down in the agreement.

Should the peg be based on my most recent month or an average?

A trailing average, usually over the prior six to twelve months, is generally fairer than a single month, since a single month can be skewed by seasonality or a one-time event. Watch for a buyer proposing an unusually low single month as the baseline, since that raises your risk of an unfavorable true-up.

About the numbers

This guide doesn't quote a sourced benchmark. Figures in it are estimates or general guidance, so check them against your own numbers.

Related Guides